Remove the four rubber screw covers from encircled locations.
  • Remove the four rubber screw covers from encircled locations.

  • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

  • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

Yorum Ekle

Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
  • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

  • Be mindful of location and magnitude of applied force, so as not to damage the case.

Yorum Ekle

  • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

Yorum Ekle

  • Use fingernails to pry off minor LCD mount, as shown.

  • Remove the minor LCD

Yorum Ekle

  • Unlock the LCD main board connectors shown in red boxes on the picture .

  • Use tweezers as necessary.

Yorum Ekle

  • Place finger nails on the connector tab as shown.

  • Lift the connector tab up.

Yorum Ekle

  • Pull/pivot the LCD main board as shown in order to remove.

Yorum Ekle

  • Use a tweezers to lift up the main LCD

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Van

Üyelik tarihi: 24-06-2010

7 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 2-10, Johann Summer 2010 Cal Poly, Team 2-10, Johann Summer 2010 üyesi

CPSU-JOHANN-R10S2G10

4 Üyeler

20 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,135