Ana içeriğe geç

Giriş

Since this is step one, you will just need to start with your camera.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the battery and memory card from the device.
    • Remove the battery and memory card from the device.

  2. Remove 4 screws from the right side of the camera.
    • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

  3. Remove the single 3.4mm screw on the left side of the camera.
    • Remove the single 3.4mm screw on the left side of the camera.

  4. PC Laptop Batteries

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Hemen Alışveriş Yapın

    PC Laptop Batteries

    Batteries for all the top PC brands, backed by our Quality Guarantee.

    Hemen Alışveriş Yapın
  5. Remove 5 screws from the base of the camera.
    • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

  6. Slowly slide the back cover away from the device
    • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

  7. Detach both ribbon cables using a spudger. Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
    • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

  8. Remove the back casing from the camera.
    • Remove the back casing from the camera.

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 farklı kişi bu kılavuzu tamamladı.

Ben Canfield

Üyelik tarihi: 10-10-2010

403 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-21, Regan Fall 2010 Cal Poly, Team 9-21, Regan Fall 2010 üyesi

CPSU-REGAN-F10S9G21

4 Üyeler

7 adet Kılavuz yazıldı

Bir Yorum

That is not a disassembly! All is shows is taking the back of the camera off. How about showing how to disassembly the camera down to its individual components and make repairs, like getting the lens to extend of fixing a sticking shutter.

JR Tan - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 7

Her zaman: 6,167