Ana içeriğe geç

Giriş

How to remove the screen.

  1. Push open the latch and remove the battery. Push open the latch and remove the battery.
    • Push open the latch and remove the battery.

  2. Twist off the antenna. Pop off the transparent cylinder.
    • Twist off the antenna.

    • Pop off the transparent cylinder.

  3. Remove the five screws as shown.
    • Remove the five screws as shown.

  4. Carefully pry the back plate off.
    • Carefully pry the back plate off.

  5. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  6. Carefully detach golden screen connector. Carefully detach golden screen connector.
    • Carefully detach golden screen connector.

  7. Pop out the logic board with spudger. Caution: Do not touch with bare hands, use tweezers or wash hands before contact.
    • Pop out the logic board with spudger.

    • Caution: Do not touch with bare hands, use tweezers or wash hands before contact.

  8. Place the logic board on a clean tray. Place the logic board on a clean tray.
    • Place the logic board on a clean tray.

  9. Remove the hinge on the phone. Put pressure on the spring with the screwdriver to unhinge phone.
    • Remove the hinge on the phone.

    • Put pressure on the spring with the screwdriver to unhinge phone.

    • Make sure to pull the gold wire through, don't let it rip.

  10. Remove the four screws as shown Use the spudger to pry it open, excessive force may be necessary. Use the spudger to pry it open, excessive force may be necessary.
    • Remove the four screws as shown

    • Use the spudger to pry it open, excessive force may be necessary.

  11. Remove the three screws that hold the big speaker Caution: The wires are attached to the screen and should be removed with care. Caution: The wires are attached to the screen and should be removed with care.
    • Remove the three screws that hold the big speaker

    • Caution: The wires are attached to the screen and should be removed with care.

  12. Remove the three screws as shown. Pull off the metal bracket.
    • Remove the three screws as shown.

    • Pull off the metal bracket.

  13. Use the spudger to pop off the screen. Pop off the Microphone/Speaker as well. Place all of the components on a clean tray and clean environment.
    • Use the spudger to pop off the screen.

    • Pop off the Microphone/Speaker as well.

    • Place all of the components on a clean tray and clean environment.

Sonuç

To reassemble your device, follow these instructions in reverse order.

doconnor

Üyelik tarihi: 19-04-2010

25 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 10-43, Garner Spring 2010 Cal Poly, Team 10-43, Garner Spring 2010 üyesi

CPSU-GARNER-S10S10G43

5 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 5

Her zaman: 1,809