Disassembling Sony Clie PEG-SL10
Steve ve 5 diğer katkıda bulunanlar
En son 21 Ara 2022 tarihinde güncellendi
Görüntüleme: 2,4 B
İstatistikleri görüntüle:
- Son 24 Saat:
- 1
- Son 7 Gün:
- 16
- Son 30 Gün:
- 52
- Her zaman:
- 2.448
Yorumlar: 0
Hiç kimse bu kılavuza yorum bırakmadı. Birinci olacak mısın?
Go to guide commentsTamamlandı: 0 1
Hiç kimse bu kılavuzu "tamamlandı" olarak işaretlemedi. İlk mi olacaksın?
1 kişi bu kılavuzu "tamamlandı" olarak işaretledi. Bu sensin - harika iş!
Sık Kullanılanlar: 0 1
Hiç kimse bu kılavuzu favorilere eklemedi (ve abone olmadı). İlk mi olacaksın?
1 kişi bu kılavuzu favorilerine ekledi (ve abone oldu) — ve bu sizsiniz!
Giriş
1. adıma git ↓This guide shows you how to disassemble a Sony Clie PEG-SL10 through an easy step-by-step process. All you need to perform this repair is a Phillips #0 screwdriver and no additional special skills are required.
This is a precursor to any other repair you may want to do on this device and also allows you to get a good look at its internal workings.
Attached to this guide at the bottom of the page is the Sony Clie PEG-SL10 User Manual.
Neye ihtiyacın var
Aletler
-
-
-
Start by holding your Sony Clie PEG-SL10 face-up in your hand.
FixBot'a Sor
-
-
-
Turn your Sony Clie face-up.
-
Using a Phillips #0 screwdriver, remove the six case screws on the sides and bottom of the device.
-
-
-
Turn the Sony Clie face down and open the back case by prying open the left side of the device.
-
-
-
Gently pry off the right side off the back panel and set it aside, leaving room for the scroll wheel at the upper right corner.
-
-
-
Using a Phillips #0 screwdriver, remove the two screws holding the scroll wheel in place.
-
-
-
Pull out both sides of the clip to remove the scroll wheel power cable from the device.
-
-
-
Using a Phillips #0 screwdriver, unscrew the two screws towards the bottom sides of the Sony Clie to remove the battery harness.
-
-
-
-
Pull the power cable from the socket located above the upper right side of the battery harness.
-
-
-
Gently pull out the clips to remove the bottom power cables from the motherboard after removing the battery harness.
-
-
-
Rotate the motherboard 180 degrees so that it is upside down facing toward you to expose the power cables on the other side.
-
-
-
Gently pull out the clips to remove the top power cables from the motherboard.
-
-
To reassemble your device, follow these instructions in reverse order.
Ekli Belgeler
Ekip
James Madison, Team 1-4, Allen Fall 2011 James Madison, Team 1-4, Allen Fall 2011 üyesi
JMU-ALLEN-F11S1G4
3 Üyeler
48 adet Kılavuz yazıldı
