Parçalar

Hiçbir parçaya gerek yok.

  1. Using the Phillips #0 in the bit driver, carefully loosen and remove the single  5mm screw.
    • Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

    • With the retaining screw removed, lift the panel upwards to separate it from the netbook.

    Yorum Ekle

  2. To replace the panel, do step 1 in reverse:
    • To replace the panel, do step 1 in reverse:

      • Align the panel slots in the appropriate grooves and set in place.

      • With the bit driver, replace the screw to secure the RAM panel.

    Yorum Ekle

    • Using the bit driver and the Phillips bit, remove both of the panel's retaining screws.

    • With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

    • The hard drive is located beneath this cover and is now accessible.

    Yorum Ekle

    • To replace the hard drive panel, do step 3 in reverse:

      • Place the panel back in its original position and press down.

      • If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

      • With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Üyelik tarihi: 18-10-2013

943 İtibar

9 adet Kılavuz yazıldı

Takım

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 üyesi

CLEM-BENSON-F13S14G2

3 Üyeler

9 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 3

Her zaman: 591