Eşyalarını Tamir Et Topluluk Mağaza

Dopo Double Power 7 Battery Replacement

Giriş

Skills you will need to be familiar with are soldering. Besides a new battery, you will also need access to a soldering kit.

Neye ihtiyacın var

  1. Dopo Double Power 7 Battery Replacement, Rear Panel: adım 1, 1 resimden 1.

    • The rear panel is secured to the front case and can simply be pried apart without damage.

    Düzenle

  2. Dopo Double Power 7 Battery Replacement: adım 2, 1 resimden 1.

    • Carefully, wedge the plastic opening tool in-between the seam that separates both halves of the tablet.

    Düzenle

  3. Dopo Double Power 7 Battery Replacement: adım 3, 1 resimden 1.

    • Run the plastic opening tool along the seam looking for the clips and lift up on the rear panel.

    Düzenle

  5. Dopo Double Power 7 Battery Replacement: adım 4, 1 resimden 1.

    • The rear panel should come completely off.

    Düzenle

  6. Dopo Double Power 7 Battery Replacement, Battery: adım 5, 1 resimden 1.

    • Cut only the red and black wires attaching the battery to the motherboard.

    • Be sure to remove any remaining wire attached to the motherboard.

    Düzenle

  7. Dopo Double Power 7 Battery Replacement: adım 6, 1 resimden 1.

    • Using a metal spudger, carefully pry the battery away from the digitizer.

    • Be careful to not damage the battery. This could result in injury.

    Düzenle

  8. Dopo Double Power 7 Battery Replacement: adım 7, 1 resimden 1.

    • Using wire strippers, strip the ends of the red and black wires connected to the the new battery back about a 1/8".

    • Twist the strands of the spliced wire together.

    • Using a soldering iron, apply heat to one bare wire connections you have just made.

    • When the connection is hot enough melt solder on the opposite side of the wire to the iron as shown in the image. Do not melt to much solder.

    • Once connection is made wait for it to cool off and gently pull each side of the wire to test durability.

    • Repeat this process with the other wire.

    • If you do not have access to a soldering iron, leave the old battery wires attached to the motherboard and simply splice the new battery's wires to them.

    • This video provides basic instructions for splicing wires using crimping and heat shrink technique.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

mike pelosi

Üyelik tarihi: 10/30/15

682 İtibar

6 adet Kılavuz yazıldı

Rozetler: 12

+9 tane daha rozet

Ekip

UMass Dartmouth, Team 1-2, Miles Fall 2015 UMass Dartmouth, Team 1-2, Miles Fall 2015 üyesi

UMASSD-MILES-F15S1G2

4 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 990