Skip to main content

Giriş

The power board is found adjacent to the motherboard inside the device. This guide will take you through the steps of removing the powerboard for replacement.

Parçalar

Hiçbir parça belirtilmedi.

  1. Use a Phillips #1 screwdriver to remove the four 5mm screws that connect the black outer shell to the silver back of the device. Use a Phillips #1 screwdriver to remove the four 5mm screws that connect the black outer shell to the silver back of the device.
    • Use a Phillips #1 screwdriver to remove the four 5mm screws that connect the black outer shell to the silver back of the device.

  2. Use a Phillips #1 screwdriver to remove the two 5mm screws on the left and right side panels.
    • Use a Phillips #1 screwdriver to remove the two 5mm screws on the left and right side panels.

    • There is one screw on each side that secures the cover to the body of the device.

  3. Lift the black cover to a 45 degree angle from the rear of the device and pull away from the device.
    • Lift the black cover to a 45 degree angle from the rear of the device and pull away from the device.

    • Check that the power cord is not preventing the device from opening or closing.

  4. Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın
  5. Remove the 9-pin white wire connecting the power board to the mother board. Remove the 9-pin white wire connecting the power board to the mother board.
    • Remove the 9-pin white wire connecting the power board to the mother board.

  6. Remove the front of the device  by removing the two screws, holding it the the body of the device. Make sure to place the grounding wire between the screw and the device when reassembling.
    • Remove the front of the device by removing the two screws, holding it the the body of the device.

    • Make sure to place the grounding wire between the screw and the device when reassembling.

  7. Remove the 4 screws holding the power board the the body of the device. Remember to connect the grounding wire to the screw next to the front panel and optical drive when reassembling.
    • Remove the 4 screws holding the power board the the body of the device.

    • Remember to connect the grounding wire to the screw next to the front panel and optical drive when reassembling.

  8. Remove the white clip. Remove the white clip.
    • Remove the white clip.

  9. Remove the power supply board.
    • Remove the power supply board.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 16

All Time: 199