Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Ecovacs Deebot 900 Front Bumper Replacement

Yazan: Gillian Blumer (ve 3 başka katılımcı)
  • Yorumlar: 2
  • Favoriler: 0

Zorluk

Çok kolay

Adımlar

9

Gerekli Süre

2 - 5 dakika

Bölümler

2

İşaretler

1

Better Introduction

Daha iyi giriş

Girişi tamamlayarak ya da daha iyi hale getirerek bu kılavuzu geliştirin.

Giriş

The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.

  1. Remove all the brushes from the Deebot.

    • Remove all the brushes from the Deebot.

    Düzenle

  2. Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    • Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    Düzenle

  3. Remove the battery cover.

    • Remove the battery cover.

    Düzenle

  5. Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Be careful not to rip out the battery cable.

    Düzenle

  6. Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    • Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    Düzenle

  7. Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​ Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    Düzenle

  8. Remove the black strip on the bottom of the bumper.

    • Remove the black strip on the bottom of the bumper.

    Düzenle

  9. Carefully lift up the bumper untill it pops out of place.​ Carefully lift up the bumper untill it pops out of place.​

    • Carefully lift up the bumper untill it pops out of place.​

    Düzenle

  10. Disconnect the two cables connecting the bumper to the body of the Deebot. Remove the front bumper from the device.

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 gün: 37

Son 30 gün: 202

Her zaman: 1,220