Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Ecovacs Deebot 900 Motherboard Replacement

Yazan: Gillian Blumer (ve 3 başka katılımcı)
  • Yorumlar: 1
  • Favoriler: 0

Zorluk

Çok zor

Adımlar

10

Gerekli Süre

5 - 15 dakika

Bölümler

3

İşaretler

1

Better Introduction

Daha iyi giriş

Girişi tamamlayarak ya da daha iyi hale getirerek bu kılavuzu geliştirin.

Giriş

The motherboard is a crucial aspect to controlling the Ecovacs Deebot 900. Unfortunately, the motherboard is easily fried if the robot accidentally vacuums water and may need to be replaced. Use this guide to replace the motherboard in the Ecovacs Deebot 900.

  1. Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​ Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    Düzenle

  2. Remove the black strip on the bottom of the bumper.

    • Remove the black strip on the bottom of the bumper.

    Düzenle

  3. Carefully lift up the bumper untill it pops out of place.​ Carefully lift up the bumper untill it pops out of place.​

    • Carefully lift up the bumper untill it pops out of place.​

    Düzenle

  4. Disconnect the two cables connecting the bumper to the body of the Deebot. Remove the front bumper from the device.

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    Düzenle

  6. Using a Phillips #00 screwdriver, take out the six screws around the perimeter of the bottom case. Using a Phillips #00 screwdriver, take out the six screws around the perimeter of the bottom case.

    • Using a Phillips #00 screwdriver, take out the six screws around the perimeter of the bottom case.

    Düzenle

  7. Insert a Jimmy into the seam and work all the way around the robot. Disconnect the two cables and remove the bottom case from the device.

    • Insert a Jimmy into the seam and work all the way around the robot.

    • Disconnect the two cables and remove the bottom case from the device.

    Düzenle

  8. Using a Phillips #00 screwdriver, remove the two black screws holding the motherboard in place.​

    • Using a Phillips #00 screwdriver, remove the two black screws holding the motherboard in place.​

    Düzenle

  9. Carefully remove the ribbon cables connected to the top of motherboard.

    • Carefully remove the ribbon cables connected to the top of motherboard.

    • Keep track of where the cables connect to the motherboard.

    Düzenle

  10. Remove the last three ribbon cables on the underside of the motherboard.​

    • Remove the last three ribbon cables on the underside of the motherboard.​

    Düzenle

  11. Lift the motherboard out of the Deebot and remove it from the device.

    • Lift the motherboard out of the Deebot and remove it from the device.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 20

Son 30 gün: 83

Her zaman: 694