Eşyalarını Tamir Et Topluluk Mağaza

Edwin the Duck Motherboard Replacement

Giriş

Edwin the interactive toy cannot work if the central most crucial part of Edwin, which is the motherboard, does not work. If there is water damage, and Edwin is no longer working, this guide will take you through the steps of replacing it.

Neye ihtiyacın var

  1. Edwin the Duck Motherboard Replacement, Motherboard: adım 1, 2 resimden 1. Edwin the Duck Motherboard Replacement, Motherboard: adım 1, 2 resimden 2.

    • Unscrew the four 9mm screws with a T8 screwdriver bit

    • Remove the back plate off

    Düzenle

  2. Edwin the Duck Motherboard Replacement: adım 2, 2 resimden 1. Edwin the Duck Motherboard Replacement: adım 2, 2 resimden 2.

    • Carefully take off the rubber skin.

    • Be patient and don't rush. You don't want to rip or damage the rubber skin resulting in losing the waterproof cover.

    Düzenle

  3. Edwin the Duck Motherboard Replacement: adım 3, 1 resimden 1.

    • Using the J1 screwdriver bit, unscrew all six 9 mm screws that run along the border.

    Düzenle

  5. Edwin the Duck Motherboard Replacement: adım 4, 2 resimden 1. Edwin the Duck Motherboard Replacement: adım 4, 2 resimden 2.

    • Use the plastic opening tool to open the inside of the duck.

    • Be very careful when splitting the two halves apart. There are wires connecting to both sides. Remember to open slowly.

    Düzenle

  6. Edwin the Duck Motherboard Replacement: adım 5, 2 resimden 1. Edwin the Duck Motherboard Replacement: adım 5, 2 resimden 2.

    • Using the plastic opening tool pull up the black tab up until it stops.

    • Be careful not to pull up the black tab too far up, otherwise the cable won't be secure anymore.

    • Pull up the white cable tab, up slowly

    Düzenle

  7. Edwin the Duck Motherboard Replacement: adım 6, 1 resimden 1.

    • Use the J1 screwdriver bit to unscrew all four 9 mm screws attached to the motherboard.

    Düzenle

  8. Edwin the Duck Motherboard Replacement: adım 7, 1 resimden 1.

    • Remove the top connector as you see in the picture.

    • Replace the new motherboard and you are finished.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

Caleb Kim

Üyelik tarihi: 10/18/17

143 İtibar

1 Kılavuz yazıldı

Rozetler: 6

+3 tane daha rozet

Ekip

UW Tacoma, Team S1-G4, Rose Fall 2017 UW Tacoma, Team S1-G4, Rose Fall 2017 üyesi

UWT-ROSE-F17S1G4

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 4

Son 30 gün: 7

Her zaman: 399