Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Before you start, make sure your vacuum is unplugged the power outlet. Press and hold down the black button below the handle while pulling the pole out.
    • Before you start, make sure your vacuum is unplugged the power outlet.

    • Press and hold down the black button below the handle while pulling the pole out.

  2. Press the black separator switch to separate the top and bottom halves of the vacuum. Press the black separator switch to separate the top and bottom halves of the vacuum.
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

  3. Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın

    Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın
  4. Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown. Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing. Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

  5. Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.
    • Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

  6. On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing. Re-insert the chrome plated piece into the center track.
    • On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing.

    • Re-insert the chrome plated piece into the center track.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Evan Fodi

Üyelik tarihi: 24-09-2013

122 İtibar

2 adet Kılavuz yazıldı

Takım

UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 üyesi

UMASSD-GULBRANDSEN-F13S1G1

3 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 310