Parçalar

Hiçbir parçaya gerek yok.

Make sure that your vacuum is unplugged from a power source. Press the black button just below the handle and extend the pole fully.
  • Make sure that your vacuum is unplugged from a power source.

  • Press the black button just below the handle and extend the pole fully.

Yorum Ekle

Press the black separator switch to separate the top and bottom halves of the vacuum. Press the black separator switch to separate the top and bottom halves of the vacuum.
  • Press the black separator switch to separate the top and bottom halves of the vacuum.

Yorum Ekle

Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown. Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing. Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.
  • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

  • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

Yorum Ekle

If the external switch is slightly misaligned as shown, realign it with the internal switch. Make sure the spring loaded button on the underside of the housing is intact when reassembling the motor housing. It is prone to eject when opening the motor housing. Make sure the spring loaded button on the underside of the housing is intact when reassembling the motor housing. It is prone to eject when opening the motor housing.
  • If the external switch is slightly misaligned as shown, realign it with the internal switch.

  • Make sure the spring loaded button on the underside of the housing is intact when reassembling the motor housing. It is prone to eject when opening the motor housing.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Evan Fodi

Üyelik tarihi: 24-09-2013

122 İtibar

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 10

Son 30 Gün: 38

Her zaman: 949