Ana içeriğe geç

Giriş

This repair guide will show you how to replace the screen on a Fossil Q Marshal Gen 2 smartwatch. Be careful not to damage the wiring or the metal connectors on your smartwatch.

Parçalar

Hiçbir parça belirtilmedi.

  1. Squeeze retaining pins together to release chain from watch body. This can be done by hand or with tweezers.
    • Squeeze retaining pins together to release chain from watch body. This can be done by hand or with tweezers.

    • Remove chain from opposing side of watch body.

  2. Use tweezers to grip the notches on the back cover, then unscrew the back cover (counter-clockwise) from the watch housing.
    • Use tweezers to grip the notches on the back cover, then unscrew the back cover (counter-clockwise) from the watch housing.

    • There is an actual tool made to remove this back cover, using the right tool may save you from scratching the back of watch with tweezers. The backcover tool can be purchased online, a local jeweler may also be willing to remove it for you.

  3. Utilize tweezers or a spudger or your fingers to pull the black wire connector from the motherboard. Utilize a spudger to pull the orange connector off of the motherboard.
    • Utilize tweezers or a spudger or your fingers to pull the black wire connector from the motherboard.

    • Utilize a spudger to pull the orange connector off of the motherboard.

  4. Utilize tweezers to pull the white battery connector from the motherboard.
    • Utilize tweezers to pull the white battery connector from the motherboard.

  5. The internal electronics can now be pulled out of the watch as one unit leaving the screen remaining in the watch housing. Taking the flat end of the spudger, pry it up. Taking the flat end of the spudger, pry it up.
    • The internal electronics can now be pulled out of the watch as one unit leaving the screen remaining in the watch housing.

    • Taking the flat end of the spudger, pry it up.

  6. The screen can now be removed out of the front-side of the watch. The screen can now be removed out of the front-side of the watch.
    • The screen can now be removed out of the front-side of the watch.

Sonuç

To reassemble your device, follow these instructions in reverse order.

11 farklı kişi bu kılavuzu tamamladı.

Matthew Tucker

Üyelik tarihi: 07-11-2017

553 İtibar

3 adet Kılavuz yazıldı

Takım

IUPUI, Team S2-G5, Harley Fall 2017 IUPUI, Team S2-G5, Harley Fall 2017 üyesi

IUPUI-HARLEY-F17S2G5

3 Üyeler

6 adet Kılavuz yazıldı

16 Yorum

Where can i find a replacement screen for the founder q 2.0 version?

Jack Seitz - Yanıt

Where can I buy replacement screen for gen 1

David Aslamazashvili -

Is the screen glued to the bezel of the watch?

Jose - Yanıt

Hello,

Do you have spare parts for the Fossil Q Marshal gen 2 watch?

Alexis Stellato - Yanıt

Where can I find a replacement screen for this devise?, I’ve done a little searching but I’m struggling to find someone who sells the replacement parts.

evans.nathan6 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 gün: 35

Son 30 gün: 141

Her zaman: 15,999