Giriş

How to remove and replace the logic board.

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove the batteries from the camera to prevent danger of electric shock.
    • Remove the batteries from the camera to prevent danger of electric shock.

    Yorum Ekle

  2. Locate all five screws on the camera. Then proceed to remove all the screws.
    • Locate all five screws on the camera. Then proceed to remove all the screws.

    Yorum Ekle

    • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

    • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

    Yorum Ekle

    • Remove outer case. Pull the back away from the main body of the camera.

    Yorum Ekle

    • Locate the LCD screen and anchoring screw.

    • Remove screw.

    Yorum Ekle

    • Carefully pull the LCD screen away from the board it is connected to.

    Yorum Ekle

    • Push both blue switches away from the holding device to unleach lcd ribbon.

    • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

    Yorum Ekle

    • Carefully detach the ribbon from where it was connected by the blue pins.

    Yorum Ekle

    • Now that everything has been disconnected from the board, remove LCD screen.

    Yorum Ekle

    • Remove the two screws holding the circuit board down.

    Yorum Ekle

    • Remove black sticky tape from circuit board and camera case.

    Yorum Ekle

    • Gently pull the circuit board away from the front side of the camera.

    • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

    Yorum Ekle

    • Remove the logic board by pulling straight away from assembly.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Cody

Üyelik tarihi: 18-04-2010

47 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 7-11, Maness Spring 2010 Cal Poly, Team 7-11, Maness Spring 2010 üyesi

CPSU-MANESS-S10S7G11

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 3,599