Giriş

The Selector is an important part of the camera because it controls the LCD screen. To replace it, follow the below steps.

Aletler

Hiçbir alete gerek yok.

Parçalar

Hiçbir parçaya gerek yok.

Turn the camera upside down so you can access the battery chamber.
  • Turn the camera upside down so you can access the battery chamber.

  • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Yorum Ekle

Push the battery chamber latch in the direction of the front of the camera.  Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.
  • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Yorum Ekle

  • With the battery chamber open, remove the old batteries.

  • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Yorum Ekle

  • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Yorum Ekle

  • Carefully pry away the rear housing cover with the plastic opening tool.

Yorum Ekle

  • Remove the rear housing cover by carefully pulling it away from the camera.

Yorum Ekle

  • To Replace the Selection button, carefully pull the button until the button has been fully detached.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Ugent Dailey

Üyelik tarihi: 20-01-2015

119 İtibar

1 Kılavuz yazıldı

Takım

USF Tampa, Team 7-1, Remmell Winter 2015 USF Tampa, Team 7-1, Remmell Winter 2015 üyesi

USFT-REMMELL-W15S7G1

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 15

Her zaman: 495