GeeksPhone Keon Camera Replacement

Giriş

Note: The motherboard does not have to be removed from the phone in order to remove the camera.

This guide can be used to replace the camera if it is no longer working properly.

Neye ihtiyacın var

Adım 1 Battery

GeeksPhone Keon Camera Replacement, Battery: adım 1, 2 resimden 1.

GeeksPhone Keon Camera Replacement, Battery: adım 1, 2 resimden 2.

Insert the plastic opening tool into the seam between the front of the device and the rear cover.
Slide the plastic opening tool from the bottom of the phone to the top.
Use the plastic opening tool to free all the clips attached to the phone.

Düzenle

Adım 2

Lift the cover away from the phone.

Düzenle

Adım 3

Insert the plastic opening tool into the groove between the bottom of the phone and the battery.
Lift the battery with the plastic opening tool and finish removing battery by hand.

Düzenle

Adım 4 Back Plate

GeeksPhone Keon Camera Replacement, Back Plate: adım 4, 2 resimden 1.

GeeksPhone Keon Camera Replacement, Back Plate: adım 4, 2 resimden 2.

Remove the two 5mm T4 screws on the sides of the small orange plate.

Düzenle

Adım 5

Gently remove the small orange plate by pulling it down.

Düzenle

Adım 6

Remove the following screws securing the back plate to the device:
Two silver 2mm T3 screws
Five black 3mm T3 screws

Düzenle

Adım 7

GeeksPhone Keon Camera Replacement: adım 7, 3 resimden 3.

Slightly lift up the bottom corner of the backplate.
Release the four clips on both sides by pulling them away from the device.

Düzenle

Adım 8

Lift the backplate away from the device.

Düzenle

Adım 9 Camera

GeeksPhone Keon Camera Replacement, Camera: adım 9, 1 resimden 1.

Lift the retaining flap on camera's ZIF connector.
Pull the ribbon cable away with tweezers.

Düzenle

Adım 10

GeeksPhone Keon Camera Replacement: adım 10, 3 resimden 3.

Carefully wiggle the camera away from the device.

Düzenle

Sonuç

To reassemble your device, follow these instructions in reverse order; but remember, the new camera must be glued back in place where the old one was removed.