Ana içeriğe geç
  1. Power off your GoPro before beginning disassembly.
    • Power off your GoPro before beginning disassembly.

    • Unclip the black latch to the camera case and open the case.

  2. Gently pry the back open by inserting a metal spudger between the case and back panel.
    • Gently pry the back open by inserting a metal spudger between the case and back panel.

  3. Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.
    • Disconnect the battery from the motherboard by unplugging the red, white, and black wires from the white adapter.

  4. Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın
  5. Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.
    • Disconnect the ribbon cable from the lens by lifting the black latch and gently pulling the ribbon cable from the socket.

  6. Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.
    • Use a Phillips screwdriver (PH000) to remove the four screws around the white plastic piece.

    • Make sure to keep track of these screws as they are very small.

  7. Carefully remove the motherboard and white plastic piece from the case.
    • Carefully remove the motherboard and white plastic piece from the case.

  8. Remove the larger ribbon cable from the daughter board by lifting the black latch and pulling the ribbon cable gently from the socket. Disconnect the smaller ribbon cable leading from the white plastic piece by simply pulling it from the socket.
    • Remove the larger ribbon cable from the daughter board by lifting the black latch and pulling the ribbon cable gently from the socket.

    • Disconnect the smaller ribbon cable leading from the white plastic piece by simply pulling it from the socket.

  9. Separate the white plastic piece from the motherboard. Separate the white plastic piece from the motherboard.
    • Separate the white plastic piece from the motherboard.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Zoe Tuggle

Üyelik tarihi: 01-04-2015

161 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 12-2, Lancaster Spring 2015 Cal Poly, Team 12-2, Lancaster Spring 2015 üyesi

CPSU-LANCASTER-S15S12G2

4 Üyeler

12 adet Kılavuz yazıldı

2 Comments

So after doing all theses steps did it resolve the problem

Anita - Yanıt

Thanks so much I really needed this guide.

Thanks, Sam

Sam Liam Matthews - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Past 24 Hours: 0

Past 7 Days: 9

Past 30 Days: 65

Her zaman: 5,660