Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

Use this guide to replace the power jack on your Graco Secure Coverage Digital Baby Monitor for nursery unit.

The power jack replacement includes the power jack and battery replacement.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver. Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver. Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver.
    • Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver.

  2. Using the plastic opening tool, pry and remove the battery cover carefully. Remove the batteries using plastic opening tool.
    • Using the plastic opening tool, pry and remove the battery cover carefully.

    • Remove the batteries using plastic opening tool.

    • Replace the batteries.

  3. Remove the two 9mm Phillips #1 screws from the rare case of the device. Place the screws in a secure place.
    • Remove the two 9mm Phillips #1 screws from the rare case of the device.

    • Place the screws in a secure place.

  4. LCD iPhone Ekran Tamir Kit'leri

    Ömür Boyu Garantimiz kapsamındaki bütçe seçeneği.

    Shop Kits

    LCD iPhone Ekran Tamir Kit'leri

    Onarım maliyetlerini düşürün, kaliteyi değil.

    Shop Kits
  5. Hold the bottom of the device with one hand and pull down to separate the front and rare cases.
    • Hold the bottom of the device with one hand and pull down to separate the front and rare cases.

    • While holding the device with one hand, use plastic opening tool to pry the edges of the front case away from the back case.

    • Take your time and apply constant force carefully to avoid breaking any other plastic parts from the device.

  6. Remove all three 7mm Phillips #1 screws from the mother board. Make sure you gently unscrew the screws with moderate force and light pressure to avoid any damages.
    • Remove all three 7mm Phillips #1 screws from the mother board.

    • Make sure you gently unscrew the screws with moderate force and light pressure to avoid any damages.

  7. Pick up the mother board carefully. Using plastic opening tool, gently pry the power jack plastic part and separate it away from the device case.
    • Pick up the mother board carefully.

    • Using plastic opening tool, gently pry the power jack plastic part and separate it away from the device case.

    • Apply constant force to avoid breaking the plastic part.

  8. Solder off the wires from the mother board.
    • Solder off the wires from the mother board.

    • There are many pins attached to the mother board, make sure you solder off the proper pins that attached to the power jack wires.

    • Replace the power jack.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Omar Abdullah

Üyelik tarihi: 06-09-2015

201 İtibar

2 adet Kılavuz yazıldı

Takım

USF Tampa, Team 6-5, Remmell Fall 2015 USF Tampa, Team 6-5, Remmell Fall 2015 üyesi

USFT-REMMELL-F15S6G5

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 70