Giriş

To remove the mounting post, you must take out all internal parts in front of the mounting post. Push down on the spring that is holding the mounting post in place. When the spring is compressed, both the mounting post and the spring can be removed if you push them away from the outside casing.

Parçalar

Hiçbir parçaya gerek yok.

Flip the GravityLight on its back and place it on a sturdy surface.
  • Flip the GravityLight on its back and place it on a sturdy surface.

  • Unscrew the three 2cm Phillips #00 screws on the back of the GravityLight’s body.

Yorum Ekle

Some of the internal pieces may loosen or fall out during disassembly.
  • Some of the internal pieces may loosen or fall out during disassembly.

  • Firmly grasp both parts of the GravityLight body and pull them apart.

Yorum Ekle

  • Place the back panel, the larger of the two pieces, on a sturdy surface with its back down.

  • Unscrew the two 2cm Phillips 00 screws on the inside of the back panel.

Yorum Ekle

  • Some of the internal pieces may loosen or fall out during disassembly.

  • Firmly grasp both parts of the back panel and pull them apart.

Yorum Ekle

  • Place the middle section on a sturdy surface.

  • Move any wires in front of the mounting post.

Yorum Ekle

  • Push down on the spring.

  • The spring is very stiff. Compressing the spring requires a moderate amount of force.

  • Push the spring and the mounting post away from the middle section and remove them from the pocket.

Yorum Ekle

  • Pull the mounting post out of the inside of the spring

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jamie Forslin

Üyelik tarihi: 26-09-2014

143 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 12-2, Forte Fall 2014 Cal Poly, Team 12-2, Forte Fall 2014 üyesi

CPSU-FORTE-F14S12G2

5 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 4

Her zaman: 403