Parçalar

Hiçbir parçaya gerek yok.

  1. Remove one 9mm T10 Torx screw from the back of the printer lid.
    • Remove one 9mm T10 Torx screw from the back of the printer lid.

  2. Pro Tech Toolkit içeren veya $100tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  3. Press outward on the plastic tab holding the back panel in place. Press outward on the plastic tab holding the back panel in place.
    • Press outward on the plastic tab holding the back panel in place.

  4. Pull the back panel towards you and lift it away from the rest of the printer cover. Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.
    • Pull the back panel towards you and lift it away from the rest of the printer cover.

    • Some ribbon cables may still be inserted through the back panel. Be careful not to damage these and they should slide out easily.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Tim

Üyelik tarihi: 15-01-2013

166 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-35, Regan Winter 2013 Cal Poly, Team 18-35, Regan Winter 2013 üyesi

CPSU-REGAN-W13S18G35

5 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 2

Son 30 Gün: 14

Her zaman: 1,789