Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

HP Mini 1000 WWAN Board Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. HP Mini 1000 WWAN Board Replacement, WWAN Board: adım 1, 1 resimden 1.
    • If present, carefully peel the piece of tape covering the WWAN board.

  2. HP Mini 1000 WWAN Board Replacement: adım 2, 2 resimden 1. HP Mini 1000 WWAN Board Replacement: adım 2, 2 resimden 2.
    • Pry the WWAN antenna connectors (2 total) up off the WWAN board.

    • During reassembly, remember to correctly connect the antenna cables to their respective terminals. The red labeled antenna is connected to the "MAIN" terminal and the blue labeled antenna is connected to the "AUX" terminal.

  3. HP Mini 1000 WWAN Board Replacement: adım 3, 3 resimden 1. HP Mini 1000 WWAN Board Replacement: adım 3, 3 resimden 2. HP Mini 1000 WWAN Board Replacement: adım 3, 3 resimden 3.
    • Remove the single 3 mm Phillips screw securing the WWAN metal bracket and WWAN board to the motherboard.

    • During reassembly, before securing the WWAN board to the upper case, be sure the metal bracket is correctly placed (as highlighted in the second picture).

    • Be cautious of the metal bracket's displacement. It can easily become lost during disassembly.

  4. HP Mini 1000 WWAN Board Replacement: adım 4, 2 resimden 1. HP Mini 1000 WWAN Board Replacement: adım 4, 2 resimden 2.
    • Upon removing the Phillips screw that secures the WWAN board to the motherboard, the WWAN board should pop up from its left side.

    • Grasp the WWAN board and pull it straight out of its socket on the motherboard.

Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 48