Giriş

Replace the wireless card in your HP Pavilion dv6000.

Lay the laptop on a flat surface, battery side up.
  • Lay the laptop on a flat surface, battery side up.

  • Remove the two screws securing the RAM shield to the lower case.

  • The screws will remain captive within the shield.

  • Lift and remove the RAM shield up from the lower case.

Yorum Ekle

Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card. Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.
  • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

  • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

Yorum Ekle

Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.
  • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

  • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

  • Grasp the wireless card and pull it straight out of its socket on the motherboard.

Yorum Ekle

Wireless card remains.
  • Wireless card remains.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

4 başka kişi bu kılavuzu tamamladı.

Ben Hirsch

Üyelik tarihi: 05-10-2010

3.589 İtibar

10 adet Kılavuz yazıldı

Takım

Cal Poly, Team 21-33, Regan Fall 2010 Cal Poly, Team 21-33, Regan Fall 2010 üyesi

CPSU-REGAN-F10S21G33

4 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 13

Son 30 Gün: 73

Her zaman: 24,735