Ensure the device is powered down and unplugged.
  • Ensure the device is powered down and unplugged.

  • Turn the device upside down with the battery compartment facing you.

  • Slide the black slider to the right and lift the battery out of its compartment.

Yorum Ekle

Locate and remove the six Phillips PM2.5×7.0 screws around the perimeter of the back plate.
  • Locate and remove the six Phillips PM2.5×7.0 screws around the perimeter of the back plate.

    • These screws do not completely detach from the device when unscrewed.

Yorum Ekle

Use the plastic opening tool to lift up the back plate and set it aside. Use the plastic opening tool to lift up the back plate and set it aside.
  • Use the plastic opening tool to lift up the back plate and set it aside.

Yorum Ekle

Locate the wifi card to the right of the RAM.
  • Locate the wifi card to the right of the RAM.

Yorum Ekle

Unplug antenna cables 1 and 2 from their leads.
  • Unplug antenna cables 1 and 2 from their leads.

    • Antenna cable 3 is not used.

Yorum Ekle

Remove the two Phillips head screws located on the battery compartment side of the wifi card.
  • Remove the two Phillips head screws located on the battery compartment side of the wifi card.

Yorum Ekle

Gently lift the wifi card up to a 45 degree angle from the side with screws.
  • Gently lift the wifi card up to a 45 degree angle from the side with screws.

Yorum Ekle

Unplug the wifi card. Unplug the wifi card.
  • Unplug the wifi card.

Yorum Ekle

These next steps are for installing your replacement wifi card. These steps are very important to ensure that you do not damage your device.
  • These next steps are for installing your replacement wifi card. These steps are very important to ensure that you do not damage your device.

  • Fully insert the replacement wifi card at a 45 degree angle, ensuring that the notch on the card lines up with the peg on the plug.

Yorum Ekle

Gently push the wifi card down until the screws can be replaced.
  • Gently push the wifi card down until the screws can be replaced.

Yorum Ekle

Connect the antenna cable 1 with lead 1 and connect antenna cable 2 with lead 2.
  • Connect the antenna cable 1 with lead 1 and connect antenna cable 2 with lead 2.

    • Wire 1 needs to be connected to lead 1 and wire 2 needs to be connected to lead 2.

    • Wire 3 and lead 3 are not used.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Anmol Mathur

Üyelik tarihi: 14-04-2014

291 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 12-34, Maness Spring 2014 Cal Poly, Team 12-34, Maness Spring 2014 üyesi

CPSU-MANESS-S14S12G34

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 6

Son 30 Gün: 23

Her zaman: 1,149