Giriş
In an age where files expand to huge sizes, it becomes necessary to have a large storage medium. Replacing a hard drive could be a challenging task, but this guide clarifies all potential issues.
Neye ihtiyacın var
-
-
Turn the laptop over to expose the bottom side.
-
Locate the battery removal switch next to the battery compartment
-
-
-
Slide the switch all the way to the left to release the battery. The battery should pop up.
-
Lift the battery out.
-
-
-
There are two hard drive bays.
-
Hard drive bay 1 is in the lower right corner.
-
Hard drive bay 2 is in the lower left corner.
-
-
-
-
To remove hard drive 2 from bay 2.
-
Using a Phillips #1 screwdriver remove the two 5 mm screws that hold the bay 2 cover in place.
-
After removing the two cover screws, lift and slide the cover out of position to access the hard drive.
-
Grab the clear plastic pull tab on top of the hard drive, and lift the hard drive from the laptop.
-
-
-
After the hard drive has been removed from the laptop, it must then be removed from its bracket.
-
Start by gently pulling the HP hard drive adapter from the end of the hard drive.
-
Using a Phillips #1 screwdriver, remove the four 3 mm bracketing screws on both sides of the hard drive bracket (2 per side) .
-
Lift the hard drive from its metal bracket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
İptal et: Bu kılavuzu tamamlamadım.
7 farklı kişi bu kılavuzu tamamladı.
Ekip
Cal Poly, Team 10-32, Maness Winter 2014 Cal Poly, Team 10-32, Maness Winter 2014 üyesi
CPSU-MANESS-W14S10G32
4 Üyeler
6 adet Kılavuz yazıldı
4 Yorum
Hello. In step 7 of the above, what is the name/part number/ size etc of the adapter/connector please ? I need one urgently.
Thanks.
yes that would be very helpfull because the new SSdrive I have will not fit even though is is the same size. I think I need some sort of an adaptor as you say.
thanks for the help
