Giriş

If the scanner glass cracks or breaks, it will need to be replaced in it's entirety. The glass is visible when you open the top of the printer so you will be able to tell if it needs replacement without taking the printer apart.

  1. Open the top of the printer. The printer should appear as shown.
    • Open the top of the printer. The printer should appear as shown.

    Yorum Ekle

  2. Use the blue plastic opening tool to pry the trim pieces all the way around the printer.
    • Use the blue plastic opening tool to pry the trim pieces all the way around the printer.

    • Loosen the pieces around the edges before pulling to remove from the printer.

    • Pull the (4) trim pieces off and set them aside.

    Yorum Ekle

    • Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.

    • The side trim pieces need to be removed before the front trim pieces.

    Yorum Ekle

    • Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

    Yorum Ekle

    • The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.

    • Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.

    • Both clips will come unattached and you can set the scanner flap aside.

    Yorum Ekle

    • Lift the scanner glass piece from the printer.

    Yorum Ekle

    • The scanner glass is attached to the plastic piece with adhesive tape.

    • Pull off the glass and re-set new piece of glass.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Laura

Üyelik tarihi: 23-10-2014

628 İtibar

3 adet Kılavuz yazıldı

Takım

Michigan Tech, Team 1-2, Lauer Fall 2014 Michigan Tech, Team 1-2, Lauer Fall 2014 üyesi

MTU-LAUER-F14S1G2

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 492