Giriş

The scanner is found underneath the scanner glass. If this piece stops moving, you will not be able to scan anything. It may need to be cleaned or replaced at this point.

Parçalar

Hiçbir parçaya gerek yok.

Open the top of the printer. The printer should appear as shown.
  • Open the top of the printer. The printer should appear as shown.

Yorum Ekle

Use the blue plastic opening tool to pry the trim pieces all the way around the printer.
  • Use the blue plastic opening tool to pry the trim pieces all the way around the printer.

  • Loosen the pieces around the edges before pulling to remove from the printer.

  • Pull the (4) trim pieces off and set them aside.

Yorum Ekle

  • Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.

  • The side trim pieces need to be removed before the front trim pieces.

Yorum Ekle

  • Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

Yorum Ekle

  • The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.

  • Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.

  • Both clips will come unattached and you can set the scanner flap aside.

Yorum Ekle

  • Lift the scanner glass piece from the printer and set it aside.

Yorum Ekle

  • Gently pick up the scanner piece as shown to see the bottom side and wiring.

Yorum Ekle

  • Gently remove the 2 wire ribbons shown by pulling them away from the scanner piece.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Charles

Üyelik tarihi: 23-10-2014

257 İtibar

2 adet Kılavuz yazıldı

Takım

Michigan Tech, Team 1-2, Lauer Fall 2014 Michigan Tech, Team 1-2, Lauer Fall 2014 üyesi

MTU-LAUER-F14S1G2

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 8

Her zaman: 404