1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic prying tool to remove the plastic frame surrounding the glass.

    Yorum Ekle

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    Yorum Ekle

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    Yorum Ekle

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    Yorum Ekle

    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    Yorum Ekle

    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Yorum Ekle

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Yorum Ekle

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a Plastic Prying Tool to detach the white wiring connector from the circuit board.

    Yorum Ekle

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    Yorum Ekle

    • Pull the printer hood upward.

    Yorum Ekle

    • With the top half of the printer separated, lift the upper section with the scanner glass away from the lower section of the printer.

    Yorum Ekle

    • With the glass facing upwards, remove the screw holding the glass in place.

    Yorum Ekle

    • Lift the glass up and away from the printer.

    • Handle glass with care.

    • Replace the broken glass piece with the replacement glass

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

garrett hall

Üyelik tarihi: 26-09-2012

49 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 2-11, Propen Fall 2012 Cal Poly, Team 2-11, Propen Fall 2012 üyesi

CPSU-PROPEN-F12S2G11

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 7

Her zaman: 2,468