Giriş

The purpose of this guide is to instruct the reader on how to replace the joypad of their HP iPAQ H2200 device.

Press and slide the battery cover tab to remove battery cover.
  • Press and slide the battery cover tab to remove battery cover.

Yorum Ekle

Pull on the black tab to lift the battery out of the battery compartment. Pull on the black tab to lift the battery out of the battery compartment.
  • Pull on the black tab to lift the battery out of the battery compartment.

Yorum Ekle

Remove the stylus by sliding it out of the slot.
  • Remove the stylus by sliding it out of the slot.

Yorum Ekle

Remove the CF card by sliding it out of the slot at the top of the device.
  • Remove the CF card by sliding it out of the slot at the top of the device.

Yorum Ekle

Press down and push the black side strips toward the top of the device to remove them.
  • Press down and push the black side strips toward the top of the device to remove them.

Yorum Ekle

Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device. Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device. Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device.
  • Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.

Yorum Ekle

Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side). Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).
  • Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).

Yorum Ekle

Open the LCD connector, where the orange strip attaches to the main board.
  • Open the LCD connector, where the orange strip attaches to the main board.

Yorum Ekle

Carefully remove the orange LCD strip from the connector.
  • Carefully remove the orange LCD strip from the connector.

Yorum Ekle

Unscrew the 2 screws located at each top corner of the main board.
  • Unscrew the 2 screws located at each top corner of the main board.

Yorum Ekle

Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.
  • Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.

Yorum Ekle

Press on the four joypad tabs on the back, and push it through and out the front.
  • Press on the four joypad tabs on the back, and push it through and out the front.

Yorum Ekle

Push the new joypad through the hole; the tabs will lock it into place.
  • Push the new joypad through the hole; the tabs will lock it into place.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Tyler Andrews

Üyelik tarihi: 13-01-2010

191 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-12, Forte Winter 2010 Cal Poly, Team 4-12, Forte Winter 2010 üyesi

CPSU-FORTE-W10S4G12

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 2,831