Ana içeriğe geç

Giriş

This step-by-step guide illustrates how to remove and replace the back case of a Pocket PC.

Parçalar

Hiçbir parça belirtilmedi.

  1. Slide the silver release tab up and simultaneously lift the cover up from the left side.
    • Slide the silver release tab up and simultaneously lift the cover up from the left side.

  2. Push the tab from left to right to remove the cover.
    • Push the tab from left to right to remove the cover.

  3. Now lift the battery up and away from the device to remove it.
    • Now lift the battery up and away from the device to remove it.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Remove the four silver screws (T5 x .25 in).
    • Remove the four silver screws (T5 x .25 in).

  6. Remove the single black screw (T5 x .125 in) beneath the HP sticker.
    • Remove the single black screw (T5 x .125 in) beneath the HP sticker.

  7. Next, use your plastic removal tool to separate the gray back from the black center piece. For better results, start the separation at the corner piece.
    • Next, use your plastic removal tool to separate the gray back from the black center piece.

    • For better results, start the separation at the corner piece.

  8. Remove the back case.
    • Remove the back case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

John Pagliero

Üyelik tarihi: 27-01-2011

897 İtibar

7 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-39, Regan Winter 2011 Cal Poly, Team 3-39, Regan Winter 2011 üyesi

CPSU-REGAN-W11S3G39

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 681