Slide the silver release tab up and simultaneously lift the cover up from the left side.
  • Slide the silver release tab up and simultaneously lift the cover up from the left side.

Yorum Ekle

Push the tab from left to right to remove the cover.
  • Push the tab from left to right to remove the cover.

Yorum Ekle

  • Now lift the battery up and away from the device to remove it.

Yorum Ekle

  • Remove the four silver screws (T5 x .25 in).

Yorum Ekle

  • Remove the single black screw (T5 x .125 in) beneath the HP sticker.

Yorum Ekle

  • Next, use your plastic removal tool to separate the gray back from the black center piece.

  • For better results, start the separation at the corner piece.

Yorum Ekle

  • Remove the back case.

Yorum Ekle

  • Now that the back cover is removed, remove the small screw (#00 Philips x .17) to the left of the SD card slot

Yorum Ekle

  • Next you will need to unlock and remove the ribbon cable

  • Carefully pull back on both sides of the brown bar using metal tweezers, unlocking the cable and slipping it out of the connector

  • The bar, connector, and cable are fragile components that can be easily broken

Yorum Ekle

  • Next you need to remove the wire off the bottom of the mother board

  • The easiest method is to use some metal tweezers and grip the plug close to the connector.

  • Make sure all these connections are properly disconnected before separation of the motherboard

Yorum Ekle

  • Next use your plastic removal tool and separate the silver front case from the black frame.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

John Pagliero

Üyelik tarihi: 27-01-2011

886 İtibar

7 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-39, Regan Winter 2011 Cal Poly, Team 3-39, Regan Winter 2011 üyesi

CPSU-REGAN-W11S3G39

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,179