Skip to main content

Giriş

In this repair guide you will be replacing the daughterboard in the HTC Desire 610. After doing this replacement, you will fix the micro USB port and also be able to successfully charge your phone again.

  1. Open the SD card slot.
    • Open the SD card slot.

  2. Using plastic opening tool, take off the back cover of the phone. Using plastic opening tool, take off the back cover of the phone. Using plastic opening tool, take off the back cover of the phone.
    • Using plastic opening tool, take off the back cover of the phone.

  3. Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.
    • Using Phillips #000 Screwdriver, remove the two 2.5mm phillips head screws.

  4. Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.
    • Using Torx T5 Screwdriver, remove the four 5mm silver torx head screws.

  5. Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    Yeni bir ekran veya pil, bir tamir kiti kadar yakınında.

    Hemen Alışveriş Yapın
  6. Using Torx T5 Screwdriver, remove the four 4mm black torx screws
    • Using Torx T5 Screwdriver, remove the four 4mm black torx screws

  7. Using plastic opening tool, remove the black plastic circuit cover. Using plastic opening tool, remove the black plastic circuit cover.
    • Using plastic opening tool, remove the black plastic circuit cover.

  8. Using Torx T5 Screwdriver, remove the 4mm black torx screw.
    • Using Torx T5 Screwdriver, remove the 4mm black torx screw.

  9. Using Tweezers, disconnect antenna wire. Using Tweezers, disconnect antenna wire.
    • Using Tweezers, disconnect antenna wire.

  10. Using Tweezers, remove loud speaker that is being held by small adhesive. When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone. When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.
    • Using Tweezers, remove loud speaker that is being held by small adhesive.

    • When putting loud speaker back on, the prongs sticking up should be on the side closer to the top of the phone.

  11. Using Tweezers, peel back gray adhesive. Using Tweezers, peel back gray adhesive.
    • Using Tweezers, peel back gray adhesive.

  12. Using Tweezers, flip the white strip upward so it sits 90°. Using Tweezers, flip the white strip upward so it sits 90°.
    • Using Tweezers, flip the white strip upward so it sits 90°.

  13. Using plastic opening tool, pry up green plate and pull outward. Daughterboard is off. Get new daughterboard and reverse steps. Daughterboard is off. Get new daughterboard and reverse steps.
    • Using plastic opening tool, pry up green plate and pull outward.

    • Daughterboard is off. Get new daughterboard and reverse steps.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Austin Phelps

Üyelik tarihi: 31-01-2016

194 Reputation

1 Kılavuz yazıldı

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 1,486