Ana içeriğe geç

What you need

  1. HTC HD2 Camera Replacement, Battery: adım 1, 1 resimden 1.
    • Carefully pull the rear cover from the back of the phone.

    • Place a finger beneath the small lip on the left side of the battery.

  2. HTC HD2 Camera Replacement: adım 2, 2 resimden 1. HTC HD2 Camera Replacement: adım 2, 2 resimden 2.
    • Lay the phone down on it's screen.

    • Lift up on the lip and pull the battery from the phone.

  3. HTC HD2 Camera Replacement, Midframe: adım 3, 2 resimden 1. HTC HD2 Camera Replacement, Midframe: adım 3, 2 resimden 2.
    • Remove the four black 3.5mm T5 screws from the back of the phone.

  4. HTC HD2 Camera Replacement: adım 4, 2 resimden 1. HTC HD2 Camera Replacement: adım 4, 2 resimden 2.
    • Insert the flat end of a spudger between the midframe and the display.

    • Slide the spudger along the seam between the frame and the display.

    • Using the spudger for leverage, carefully pry the midframe away from the display assembly.

    • This process will take some effort. Continue to pry slowly and carefully until the frame begins to detach.

    • As it releases, pull the midframe away from the phone.

    • The volume control tab may fall off during removal. It can be easily reattached.

  5. HTC HD2 Camera Replacement, Camera: adım 5, 3 resimden 1. HTC HD2 Camera Replacement, Camera: adım 5, 3 resimden 2. HTC HD2 Camera Replacement, Camera: adım 5, 3 resimden 3.
    • Disconnect the flash cable from its socket in the bottom of the motherboard.

    • Carefully pull the cable from its groove in the frame, working your way back to the camera.

  6. HTC HD2 Camera Replacement: adım 6, 3 resimden 1. HTC HD2 Camera Replacement: adım 6, 3 resimden 2. HTC HD2 Camera Replacement: adım 6, 3 resimden 3.
    • Pull the camera flash and cover off of the board.

    • You may need to peel back the sticker that sits behind the battery.

    • Work carefully. Excessive force can damage the camera or motherboard.

  7. HTC HD2 Camera Replacement: adım 7, 1 resimden 1.
    • Around the camera is a thin shielding. Remove it with tweezers.

    • Using tweezers, remove the primary camera.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Sam Luedloff

Üyelik tarihi: 12-04-2011

715 İtibar

3 adet Kılavuz yazıldı

Team

Cal Poly, Team 24-55, Amido Spring 2011 Cal Poly, Team 24-55, Amido Spring 2011 üyesi

CPSU-AMIDO-S11S24G55

5 Üyeler

16 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 3

Son 30 gün: 5

Her zaman: 7,867