Eşyalarını Tamir Et Topluluk Mağaza

Harman Kardon Invoke LED Board Replacement

Giriş

If the LED lights do not function after troubleshooting, you might need to change the LED Board. For this replacement you need a Phillips #2 screw driver and a metal spudger.

Neye ihtiyacın var

  1. Harman Kardon Invoke LED Board Replacement, LED Board: adım 1, 3 resimden 1. Harman Kardon Invoke LED Board Replacement, LED Board: adım 1, 3 resimden 2. Harman Kardon Invoke LED Board Replacement, LED Board: adım 1, 3 resimden 3.

    • Use a metal spudger to remove the top cover.

    • Use a Phillips #2 screwdriver to remove three 17 mm screws.

    Düzenle

  3. Harman Kardon Invoke LED Board Replacement: adım 2, 3 resimden 1. Harman Kardon Invoke LED Board Replacement: adım 2, 3 resimden 2. Harman Kardon Invoke LED Board Replacement: adım 2, 3 resimden 3.

    • Grip larger cable connected to LED board and pull volume wheel until both are disconnected from the cable.

    • Pull lightly on the LED board to disconnect the smaller LED board cable from volume wheel.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

2 tane daha katılımcı ile

Khalid Almutairi

Üyelik tarihi: 10/02/18

85 İtibar

1 Kılavuz yazıldı

Rozetler: 2

Ekip

Eastern Washington University, Team S2-G2, Munoz Fall 2018 Eastern Washington University, Team S2-G2, Munoz Fall 2018 üyesi

EWU-MUNOZ-F18S2G2

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 1

Son 30 gün: 3

Her zaman: 503