Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Connect a voltmeter at the power supply’s connection to the circuit board and the power supply.
    • Connect a voltmeter at the power supply’s connection to the circuit board and the power supply.

    • If the the voltage at the power supply is incorrect, the power supply should be replaced.

  2. Use wire strippers to cut the wired connection to the power supply.
    • Use wire strippers to cut the wired connection to the power supply.

    • If the wires need replacing, you will need to use a soldering iron and remove the connections at the board.

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Use the wire strippers to cut off the rubber ends of the power supply wires.
    • Use the wire strippers to cut off the rubber ends of the power supply wires.

    • Use a soldering iron and solder to fuse the connections between the two wires.

  5. Test the power supply once the wires have been reconnected. If the Health o Meter still has power issues, check the connections between the new power supply and the board.
    • Test the power supply once the wires have been reconnected.

    • If the Health o Meter still has power issues, check the connections between the new power supply and the board.

    • If no issues are found, the circuit board may need to be replaced.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Dennis White Jr

Üyelik tarihi: 02-04-2018

217 İtibar

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 4

Her zaman: 47