Giriş

This guide is created to replace a damaged or broken back wheel. Tools required are a Hex Bit 4.0 tool, a bit extender, and an allen key.

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
    • Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

    • The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

    • Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

    Yorum Ekle

  2. Slide off the plastic side panel.
    • Slide off the plastic side panel.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

    • You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don't spin freely.

    Yorum Ekle

    • Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

    Yorum Ekle

    • Slide off the other plastic side panel.

    Yorum Ekle

    • On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

    • The axle pops out and the wheel easily comes off.

    • Two washers will pop out with the axle.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Luke Imai

Üyelik tarihi: 08-10-2018

133 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team S15-G5, White Fall 2018 Cal Poly, Team S15-G5, White Fall 2018 üyesi

CPSU-WHITE-F18S15G5

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 16

Son 30 Gün: 16

Her zaman: 32