Giriş
Is one side of your Hover-1 Horizon unresponsive? This is a guide to show you how to replace the left gyroscope board, the most likely culprit to your problem. This guide requires a Phillips #2 and a Phillips #1 screwdriver.
Neye ihtiyacın var
-
-
-
Remove the six 12mm Phillips #2 screws holding the base plate.
FixBot'a Sor
-
-
-
Remove the two 11mm Phillips #1 screws that hold the base plate to the body.
-
-
-
-
-
-
Remove the two connectors on either side of the board by lifting the tab and pulling out.
-
Remove the connector in the middle of the board by squeezing the tab and pulling up.
-
-
-
Remove the four 11mm Phillips #1 screws that attach the gyroscope board to the mount.
-
Lift the board to reveal the connections on the bottom.
-
-
-
Remove the middle connector by squeezing the top of the tab and pulling up.
-
-
-
Remove the four 12mm Phillips #2 screws that hold the motherboard to the base.
-
Pull the motherboard away from the gyroscope by grabbing it with two hands and pulling it to the right .
-
-
-
Unclip the black connector by squeezing both sides and pulling them apart.
-
-
To reassemble your device, follow these instructions in reverse order.
İptal et: Bu kılavuzu tamamlamadım.
Bir başkası bu kılavuzu tamamladı.
Ekip
Cal Poly, Team S13-G6, White Fall 2018 Cal Poly, Team S13-G6, White Fall 2018 üyesi
CPSU-WHITE-F18S13G6
4 Üyeler
6 adet Kılavuz yazıldı
