Ana içeriğe geç

Giriş

Does your Hover-1 Horizon not turn off? This is a guide to show you how to replace the power button, the most likely cause of your issue. This guide requires a Phillips #2 and a Phillips #1 screwdriver.

  1. Remove the six 12mm Phillips #2 screws holding the base plate. Remove the six 12mm Phillips #2 screws holding the base plate.
    • Remove the six 12mm Phillips #2 screws holding the base plate.

  2. Remove the two 11mm Phillips #1 screws that hold the base plate to the body. Remove the two 11mm Phillips #1 screws that hold the base plate to the body.
    • Remove the two 11mm Phillips #1 screws that hold the base plate to the body.

  3. Remove the base plate by lifting it up. The base plate is connected to the body with wires. The wires are long enough to set the base plate to the side. The base plate is connected to the body with wires. The wires are long enough to set the base plate to the side.
    • Remove the base plate by lifting it up.

    • The base plate is connected to the body with wires. The wires are long enough to set the base plate to the side.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Reorient the Hover-1 Horizon so the base plate opens towards you.
    • Reorient the Hover-1 Horizon so the base plate opens towards you.

  6. Remove the connector by squeezing the tab and lifting up. Remove the connector by squeezing the tab and lifting up. Remove the connector by squeezing the tab and lifting up.
    • Remove the connector by squeezing the tab and lifting up.

  7. Remove the second connector by squeezing the tab and pulling up. Remove the second connector by squeezing the tab and pulling up. Remove the second connector by squeezing the tab and pulling up.
    • Remove the second connector by squeezing the tab and pulling up.

  8. Unscrew the power button by holding the front and twisting the back nut counter-clockwise. Push the power button through the base plate to remove. A hot air gun may need to be used to remove the adhesive connecting the base plate to the power button.
    • Unscrew the power button by holding the front and twisting the back nut counter-clockwise.

    • Push the power button through the base plate to remove.

    • A hot air gun may need to be used to remove the adhesive connecting the base plate to the power button.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Christina Fong

Üyelik tarihi: 08-10-2018

159 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team S13-G6, White Fall 2018 Cal Poly, Team S13-G6, White Fall 2018 üyesi

CPSU-WHITE-F18S13G6

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 9

Her zaman: 72