Eşyalarını Tamir Et Topluluk Mağaza

Hover-1 Matrix Pad Replacement

Giriş

The pads on Hover-1 Matrix are weight sensitive, so when they sense weight, the hover board starts to move automatically. Overused pads must be replaced for the Hover-1 Matrix to move when there is a rider.

Neye ihtiyacın var

  1. Hover-1 Matrix Pad Replacement, Pad: adım 1, 2 resimden 1. Hover-1 Matrix Pad Replacement, Pad: adım 1, 2 resimden 2.

    • Remove the screws on the back of the hoverboard using a Phillips #1 screwdriver.

    • Remove the back shell from the hoverboard.

    Düzenle

  2. Hover-1 Matrix Pad Replacement: adım 2, 1 resimden 1.

    • Remove the screws from the metal layer inside the hoverboard using a Phillips #1 screwdriver.

    Düzenle

  4. Hover-1 Matrix Pad Replacement: adım 3, 1 resimden 1.

    • Separate the upper shell of the hoverboard and the metal layer inside.

    Düzenle

  5. Hover-1 Matrix Pad Replacement: adım 4, 2 resimden 1. Hover-1 Matrix Pad Replacement: adım 4, 2 resimden 2.

    • Start by identifying the motherboard, which is the green pad shown in the picture.

    • Remove the screws on the corners of the motherboard with the Phillips #1 screwdriver and take it off.

    • There are cables attached to the motherboard so go ahead and unattach them.

    Düzenle

  6. Hover-1 Matrix Pad Replacement: adım 5, 3 resimden 1. Hover-1 Matrix Pad Replacement: adım 5, 3 resimden 2. Hover-1 Matrix Pad Replacement: adım 5, 3 resimden 3.

    • Use picture 1 as a guide and move the motherboard to the other side.

    • Identify the two black rubber buttons that are shown in the second picture.

    • Remove the two rubber buttons using the Phillips #1 screwdriver.

    Düzenle

  7. Hover-1 Matrix Pad Replacement: adım 6, 1 resimden 1.

    • Removing the rubber buttons in the previous step allows you to take the pad off.

    • Finally, take off the old pad and put on a new pad.

    Düzenle
Sonuç

To reassemble your device, follow these instructions starting with step number 6 and finishing with step number 1.

Bir başkası bu kılavuzu tamamladı.

Yazar

4 tane daha katılımcı ile

Jici Zhuang

Üyelik tarihi: 10/22/18

362 İtibar

2 adet Kılavuz yazıldı

Rozetler: 6

+3 tane daha rozet

Ekip

UC Davis, Team S7-G2, Lore Fall 2018 UC Davis, Team S7-G2, Lore Fall 2018 üyesi

UCD-LORE-F18S7G2

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 12

Her zaman: 343