Ana içeriğe geç

Giriş

With mechanical disc brakes, we adjust brakes if our brake lever pulls all the way into the handle bar. This guide will show how to adjust those brakes, specifically TektroAries MD-M300. However, this process should work with other mechanical brakes too. The process is quite easy and anyone can complete the guide without extensive knowledge of bicycles.

Aletler

Parçalar

Hiçbir parça belirtilmedi.

  1. You will see a cable attached to an Allen bolt.
    • You will see a cable attached to an Allen bolt.

  2. Loosen up the bolt with the help of Hex key set.
    • Loosen up the bolt with the help of Hex key set.

  3. Now, pull the cable as much as you can. Now, pull the cable as much as you can.
    • Now, pull the cable as much as you can.

  4. Tighten up the bolt while you keep pulling the cable.
    • Tighten up the bolt while you keep pulling the cable.

  5. To center the caliper for a smooth breaking experience, loosen up the two bolts of the brake situated at top and at bottom. To center the caliper for a smooth breaking experience, loosen up the two bolts of the brake situated at top and at bottom.
    • To center the caliper for a smooth breaking experience, loosen up the two bolts of the brake situated at top and at bottom.

  6. Now, put the brake on.
    • Now, put the brake on.

  7. While putting the brake on, tighten up both the bolts. You are finished adjusting the brakes! You are finished adjusting the brakes!
    • While putting the brake on, tighten up both the bolts.

    • You are finished adjusting the brakes!

Bitiş Çizgisi

Md Abdullah

Üyelik tarihi: 03-07-2021

145 İtibar

1 Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 16

Son 30 gün: 81

Her zaman: 214