Eşyalarını Tamir Et Topluluk Mağaza

How to Test the Manometer on a Fisher Paykel Neopuff

Tıbbi Ekipman
iFixit de, bu onarım kılavuzu da tıbbi cihaz üreticisi tarafından onaylanmış değildir ya da herhangi birinin üreticiyle alâkası yoktur.

Giriş

Please refer to page 7 of the device’s Technical Manual for source information.

  1. How to Test the Manometer on a Fisher Paykel Neopuff, How to Test the Manometer on a Fisher Paykel Neopuff: adım 1, 1 resimden 1.

    • Lift the cover off the Max Pressure Relief Valve slightly and turn out of the way.

    Düzenle

  2. How to Test the Manometer on a Fisher Paykel Neopuff: adım 2, 1 resimden 1.

    • Disconnect all devices from the F&P Neopuff™/Perivent™ outlet port.

    Düzenle

  3. How to Test the Manometer on a Fisher Paykel Neopuff: adım 3, 1 resimden 1.

    • Check the manometer needle is within +/- 2 cm H2O of zero on the manometer gauge. If the manometer does not read zero, the resetting of the manometer to zero procedure should be followed.

    Düzenle

  4. How to Test the Manometer on a Fisher Paykel Neopuff: adım 4, 1 resimden 1.

    • Connect the outlet of the F&P Neopuff™/Perivent™ Infant Resuscitator to a bleed valve and a certified gauge (e.g. Mensor Digital Pressure Gauge Series 2400).

    Düzenle

    • Set the gas supply to 10 L/min.

    Düzenle

    • Completely close the maximum pressure limit valve by turning the left-handed knob completely clockwise.

    Düzenle

  7. How to Test the Manometer on a Fisher Paykel Neopuff: adım 7, 1 resimden 1.

    • With the bleed valve closed, adjust the Peak Inspiratory Pressure knob to set the pressure so that the certified gauge reads 10, 20, and 40 cm H2O.

    Düzenle

    • Check that the manometer reads within +/- 2 cm H2O of these values at each set point.

    Düzenle

    • With the pressure set to 40 cm H2O, open and close the bleed valve three times and check the manometer needle rises and falls smoothly.

    Düzenle
Sonuç

If the F&P Neopuff™/Perivent™ Infant Resuscitator fails any of these tests, the manometer should be regarded as inaccurate and replaced with a new manometer.

Yazar

1 tane daha katılımcı ile

Tyler Lin

Üyelik tarihi: 05/04/20

325 İtibar

2 adet Kılavuz yazıldı

Rozetler: 6

+3 tane daha rozet

Ekip

Cal Poly, Team S1-G6, Zimmerman Spring 2020 Cal Poly, Team S1-G6, Zimmerman Spring 2020 üyesi

CPSU-ZIMMERMAN-S20S1G6

4 Üyeler

27 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 5

Son 30 gün: 17

Her zaman: 725