Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

Use this guide to remove and replace the rear case of a Huawei P9 Plus.

Parçalar

Hiçbir parça belirtilmedi.

  1. First switch off your phone. Remove the SD and SIM card tray.
    • First switch off your phone.

    • Remove the SD and SIM card tray.

  2. Remove the two P2 Pentalobe screws on either side of the USB C port.
    • Remove the two P2 Pentalobe screws on either side of the USB C port.

  3. Use an iSclack or a suction handle to separate the display unit from the rear case. Do not fully separate the pieces as they are still connected by the fingerprint sensor cable.
    • Use an iSclack or a suction handle to separate the display unit from the rear case.

    • Do not fully separate the pieces as they are still connected by the fingerprint sensor cable.

  4. After separating the rear case flip the other half open to get to the flex connectors. With a spudger unplug the flex connector of the fingerprint sensor and the one of the side buttons. Remove the rear case.
    • After separating the rear case flip the other half open to get to the flex connectors.

    • With a spudger unplug the flex connector of the fingerprint sensor and the one of the side buttons.

    • Remove the rear case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Dominik Schnabelrauch

Üyelik tarihi: 23-11-2016

89.017 İtibar

375 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

134 Üyeler

15.682 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 8

Her zaman: 1,638