Ana içeriğe geç

Giriş

Use this guide if the Huawei Union’s camera will not work properly.

  1. Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off. Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
    • Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.

  2. Use the flat end of a spudger, or fingernail, to lift up the battery and pull out. Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
    • Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.

  3. Remove the thirteen 3mm Phillips #00 screws from the back panel.
    • Remove the thirteen 3mm Phillips #00 screws from the back panel.

  4. Use the flat end of a spudger to pry off the back panel.
    • Use the flat end of a spudger to pry off the back panel.

  5. Use the flat end of a spudger to disconnect the camera from the motherboard. Pull the camera out to remove.
    • Use the flat end of a spudger to disconnect the camera from the motherboard.

    • Pull the camera out to remove.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Brittany Achor

Üyelik tarihi: 14-02-2018

705 İtibar

6 adet Kılavuz yazıldı

Takım

USF Tampa, Team S1-G1, Nance Spring 2018 USF Tampa, Team S1-G1, Nance Spring 2018 üyesi

USFT-NANCE-S18S1G1

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 3

Her zaman: 66