Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

Hytera TC-580 Keypad Replacement

Yazan: Stuart (ve 4 başka katılımcı)
  • Yorumlar: 0
  • Favoriler: 0

Zorluk

Orta

Adımlar

10

Gerekli Süre

5 - 15 dakika

Bölümler

3

İşaretler

0

Giriş

Remove the keypad of the TC-580. This will require serious disassembly of the radio. If you aren't able to get the buttons to work or the radio doesn't seem to respond properly to key presses you should consider doing this.

  1. Remove the two 10mm Phillips #0 from the belt clip. Remove the two 10mm Phillips #0 from the belt clip.

    • Remove the two 10mm Phillips #0 from the belt clip.

    Düzenle

  2. Push in the release button and pull up on the battery to remove. Push in the release button and pull up on the battery to remove.

    • Push in the release button and pull up on the battery to remove.

    Düzenle

  3. Twist antenna counter-clockwise and set damaged antenna aside.

    • Twist antenna counter-clockwise and set damaged antenna aside.

    Düzenle

  4. Remove the volume knob by firmly lifting up on both sides of it.

    • Remove the volume knob by firmly lifting up on both sides of it.

    Düzenle

  6. Remove the orange o-ring around volume knob using tweezers.

    • Remove the orange o-ring around volume knob using tweezers.

    Düzenle

  7. Remove grey nut from base of volume knob by turning it counterclockwise with a set of tweezers.

    • Remove grey nut from base of volume knob by turning it counterclockwise with a set of tweezers.

    Düzenle

  8. Remove the brass washer from the base of the antenna slot by turning it counterclockwise with a set of tweezers.

    • Remove the brass washer from the base of the antenna slot by turning it counterclockwise with a set of tweezers.

    Düzenle

  9. Remove the two 15mm T8 Torx screws from the base of the battery cavity. Remove the two 15mm T8 Torx screws from the base of the battery cavity.

    • Remove the two 15mm T8 Torx screws from the base of the battery cavity.

    Düzenle

  10. Using a plastic opening tool, pry in between the plastic case and metal circuit board to remove the board.

    • Using a plastic opening tool, pry in between the plastic case and metal circuit board to remove the board.

    Düzenle

  11. Peel off the keypad by hand.

    • Peel off the keypad by hand.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

4 tane daha katılımcı ile

Stuart

Üyelik tarihi: 14-02-2018

431 İtibar

3 adet Kılavuz yazıldı

Rozetler: 8

+5 tane daha rozet

Takım

USF Tampa, Team S3-G4, Nance Spring 2018 USF Tampa, Team S3-G4, Nance Spring 2018 üyesi

USFT-NANCE-S18S3G4

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 115