Eşyalarını Tamir Et Topluluk Mağaza

Insignia NS-HTMC01-B Power Button Replacement

Giriş

This guide will help you replace a broken or damaged power button on the outside of the Insignia NS-HTMC01-B ceramic heater. A broken or damaged power button can prevent your heater from shutting off, or turning on.

Neye ihtiyacın var

  1. Insignia NS-HTMC01-B Power Button Replacement, Power Button: adım 1, 1 resimden 1.

    • Flip your device over so the bottom panel faces you. You should see a hole containing a screw in each corner of the device.

    • Insert a 4-inch Phillips #1 screwdriver into each hole until connected with the 20 millimeter, sharp-point screw.

    Düzenle

  2. Insignia NS-HTMC01-B Power Button Replacement: adım 2, 1 resimden 1.

    • Find the power switch, located inside the heater on the bottom left corner.

    Düzenle

  4. Insignia NS-HTMC01-B Power Button Replacement: adım 3, 1 resimden 1.

    • Using a Phillips #1 screwdriver, unscrew the two 7 millimeter screws attaching the power switch to the power button.

    Düzenle

  5. Insignia NS-HTMC01-B Power Button Replacement: adım 4, 2 resimden 1. Insignia NS-HTMC01-B Power Button Replacement: adım 4, 2 resimden 2.

    • Find the clips holding the power button in place.

    • Press down on the clips to remove the button.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

1 tane daha katılımcı ile

Jack Casey

Üyelik tarihi: 01/31/17

231 İtibar

2 adet Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

Ekip

University of North Texas, Team 1-1, Campbell Spring 2017 University of North Texas, Team 1-1, Campbell Spring 2017 üyesi

UNT-CAMPBELL-S17S1G1

3 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 125