Ana içeriğe geç

Giriş

The Insignia 2-in-1 Handheld vacuum button may get jammed or the electrical components can stop working. In either case, this guide can show you how to fix or replace the power button.

Parçalar

Hiçbir parça belirtilmedi.

  1. Push down the black button to release the dust cup. Pull the dust cup up and away from handheld portion to remove.
    • Push down the black button to release the dust cup.

    • Pull the dust cup up and away from handheld portion to remove.

  2. Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring. Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.
    • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

    • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

  3. Pull apart the red and black wires. Do so for all of the wires. (Red x1, Black x2)
    • Pull apart the red and black wires.

    • Do so for all of the wires. (Red x1, Black x2)

  4. Remove the tape holding the battery to the black housing.
    • Remove the tape holding the battery to the black housing.

    • Slide the entire battery bundle out.

  5. Remove motor and impeller housing to gain access to power button.
    • Remove motor and impeller housing to gain access to power button.

  6. Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector. Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.
    • Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

  7. Remove the two 10mm  Philips #2 screws holding the brown printed circuit board to the vacuum. Remove brown printed circuit board.
    • Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.

    • Remove brown printed circuit board.

    • Pull up on clear plastic power button assembly to remove.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Üyelik tarihi: 15-02-2018

434 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team S16-G3, Boczar Spring 2018 USF Tampa, Team S16-G3, Boczar Spring 2018 üyesi

USFT-BOCZAR-S18S16G3

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 82