Ana içeriğe geç

Giriş

The Insignia 2-in-1 stick vacuum power button can suddenly stop working or become jammed. In either case, use this guide to fix or replace the power button.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle. Pull up on the back cover of the vacuum handle and remove it. Pull up on the back cover of the vacuum handle and remove it.
    • Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.

    • Pull up on the back cover of the vacuum handle and remove it.

  2. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  3. Remove the two 10mm Phillips #2  screws on the back of the green printed circuit board. If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection. If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.
    • Remove the two 10mm Phillips #2 screws on the back of the green printed circuit board.

    • If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Üyelik tarihi: 15-02-2018

434 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team S16-G3, Boczar Spring 2018 USF Tampa, Team S16-G3, Boczar Spring 2018 üyesi

USFT-BOCZAR-S18S16G3

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 51