Giriş

This guide details the steps to take off the button pad of your Inter-tel IP 8660.

Parçalar

Hiçbir parçaya gerek yok.

Before disassembling the phone, make sure it is not plugged into power and the handset phone cord is disconnected from the handset jack.
  • Before disassembling the phone, make sure it is not plugged into power and the handset phone cord is disconnected from the handset jack.

Yorum Ekle

Unscrew the 9 highlighted screws using a #1 Phillips head screwdriver. You can use a magnetized screwdriver to draw them out. 8 mm long 11 mm long
  • Unscrew the 9 highlighted screws using a #1 Phillips head screwdriver. You can use a magnetized screwdriver to draw them out.

    • 8 mm long

    • 11 mm long

Yorum Ekle

Lift up the back cover and set it aside.
  • Lift up the back cover and set it aside.

Yorum Ekle

While holding down the motherboard, gently pull the wire harness connecting the speaker to the motherboard until it comes free.
  • While holding down the motherboard, gently pull the wire harness connecting the speaker to the motherboard until it comes free.

Yorum Ekle

Lift up the speaker.
  • Lift up the speaker.

Yorum Ekle

Lift up the motherboard and set aside
  • Lift up the motherboard and set aside

Yorum Ekle

Peel off all rubber button covers.
  • Peel off all rubber button covers.

Yorum Ekle

Remove all plastic buttons.  (Note: Look at the initial picture for locations of each button set)
  • Remove all plastic buttons. (Note: Look at the initial picture for locations of each button set)

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Juan David GutierrezFranco

Üyelik tarihi: 20-01-2012

67 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 11-24, Maness Winter 2012 Cal Poly, Team 11-24, Maness Winter 2012 üyesi

CPSU-MANESS-W12S11G24

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 663