Giriş
This guide will teach the reader to install a new Battery Circuit Connector into the battery case. This may need to be done if the batteries are not delivering electricity into the camera.
Parçalar
Hiçbir parçaya gerek yok.
-
Flip the camera over so the bottom is facing you.
-
Open the cover on the bottom by sliding it in the direction of the arrow.
-
Remove the batteries by pulling up on the top with your fingers.
-
Remove the three screws from the circuit connector.
-
Remove the connector from the battery holder door.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
İptal et: Bu kılavuzu tamamlamadım.
Bir başkası bu kılavuzu tamamladı.
Takım
Cal Poly, Team 15-13, Forte Spring 2012 Cal Poly, Team 15-13, Forte Spring 2012 üyesi
CPSU-FORTE-S12S15G13
5 Üyeler
5 adet Kılavuz yazıldı
