Giriş

This guide will aid the user in the installation of the capture button for this device. The capture button is the button that is pressed in order to take a picture. This device is to be used if for some reason the capture button breaks or is pushed into the device.

Parçalar

Hiçbir parçaya gerek yok.

  1. Flip the device so that the bottom is facing upwards. Using thumb, push the tab on the bottom in the direction indicated by the arrow and then lift the unhinged part of the tab.
    • Flip the device so that the bottom is facing upwards. Using thumb, push the tab on the bottom in the direction indicated by the arrow and then lift the unhinged part of the tab.

    Yorum Ekle

  2. Tilt device so that batteries slide out.
    • Tilt device so that batteries slide out.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully insert the flat end of the spudger into the seam on the top side of the device. Carefully twist the spudger to open the device. Repeat this step at incremental locations around the seam of the device until the two case halves separate.

    • Before completely separating the two halves, separate the case from the battery compartment cover, pulling the case apart. Take care not to break the plastic hinge as the battery compartment cover is removed.

    Yorum Ekle

    • There are two wires (one red and one black) that could get disconnected from the motherboard when prying the case apart.

    • Gently seperate the two halves of the device.

    • To remove the circuit board from the right section of the device, unscrew the two 5.6 mm Phillips #00 screws.

    • When the screws have been fully unscrewed, use the tweezers to remove them from the device.

    Yorum Ekle

    • Carefully separate the grey side bar from the case and set it aside.

    Yorum Ekle

    • Use the tweezers to grasp the bottom of the capture button. Pull the capture button away from the case and set it aside.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Katelyn Fry

Üyelik tarihi: 11-03-2013

1 İtibar

7 adet Kılavuz yazıldı

Takım

Clemson, Team 12-3, Benson Spring 2013 Clemson, Team 12-3, Benson Spring 2013 üyesi

CLEM-BENSON-S13S12G3

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 111