Turn the controller over to the backside and locate the battery cover screw.
  • Turn the controller over to the backside and locate the battery cover screw.

Yorum Ekle

The battery cover 8.0mm Phillips #2 screw is on the bottom left handle. There is a plastic washer holding the screw to the cover, so completely loosen the screw, but do not remove.
  • The battery cover 8.0mm Phillips #2 screw is on the bottom left handle. There is a plastic washer holding the screw to the cover, so completely loosen the screw, but do not remove.

Yorum Ekle

  • Once the screw is removed lift the battery cover up from the controller.

Yorum Ekle

  • Remove the 2 AA batteries.

Yorum Ekle

  • Remove both the 6.0mm Phillips #1 screws holding the D-pads in place.

Yorum Ekle

  • Insert wisdom here.

Yorum Ekle

  • Remove the four 8.1 Phillips #1 screws (red:) and (orange:)

Yorum Ekle

  • Lift the antenna holder away from the controller towards the top of the antenna.

Yorum Ekle

  • Before you separate both halves of the controller make sure the battery holder is facing you so the D-pads stay in place.

  • Separate both halves of the controller.

Yorum Ekle

  • Remove the 7.9 Phillips #1 screw that holds both the antenna and the internal chip.

Yorum Ekle

  • Remove the internal chip by pulling it away from the controller.

  • Remove both the positive(red wire) and negative(black wire) from the battery terminals.

  • Reverse the steps to put everything back together.

Where do you get the chip to replace?

Sandra Koll - Yanıt

Sonuç

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

Üyelik tarihi: 17-09-2014

219 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team 1-2, Hickman Fall 2014 USF Tampa, Team 1-2, Hickman Fall 2014 üyesi

USFT-HICKMAN-F14S1G2

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 108